Looking for interesting integrations
We adapt the software for custom solutions: sensors, protocols, non-standard control modes.
If an off-the-shelf drive does not fit the job, write to us. We take on non-standard integrations and adapt the firmware and software to your equipment — from an unusual encoder to a proprietary exchange protocol.
What we do
Custom sensors
Feedback that is not in the standard package: other encoder interfaces, external position and torque sensors.
Your protocols
Interfacing with your controller or PLC: Modbus, CAN, EtherCAT, discrete-signal handshakes.
Application modes
Special control laws, torque limits, axis synchronisation, operation inside a production line.
How to start
Describe the task
What equipment, which motor and sensor, and what does not work with a standard drive.
Assessment
We check feasibility and timing, then propose an approach and the cost of the work.
Development
We write the software, test it on your bench or ours, and hand over the firmware and documentation.
For integrators and equipment makers we run a separate programme: volume discounts and engineering support at the design stage.
Discuss the task Catalogue →